Perfume Extractor

Do you need a way to easily get perfume out of its original bottle? Than this simple print is for you. It's a simple adaptor for a perfume bottle that uses the vacuum created by a syringe to extract perfume.

I have a nice travel bottle for perfume with a screw on top, but every single time I fill it up I have to press the pump at least 30 times and finally I got tired, so I created this little thing.

Note that this works with most perfume bottles, but not all. Some have a different size pump tube.

Materials required

• a regular syringe (~4.5mm tip)

Printing requirements

• any solid plastic, PLA does just fine
• It's a pretty standard print, I did it on a stock ender 3 pro, you just may need to touch your horizontal expansion.
• Printing time: ~10min

Use

Put the syringe on the end with the wider hole and push it in. You may employ some turning action while pushing to make sure it makes a decent seal. Next remove the top cap of your perfume bottle and put the adaptor on top. Push down with the body of the syringe while pulling the plunger upward. The syringe should start filling up with perfume. You can than transfer it to another bottle or do waterer else you want to do with it.