Remix of Magnetic Dust Port (Offset Version)

This is a remix of the tool-side half of the dust magnetic dust collection fitting for the 103mm size. My bandsaw did not have clearance for the full magnetic collar to fit correctly while mounted. The remix offsets the magnetic collar from center ½", extending the length of the fitting a total of ½" also. A slight internal chamfer was used to prevent unwanted flow restriction on the new offset. No new support requirements to this version, should print well without them. I have also converted the file to STEP from the original FreeCAD file.

If it matters, this fits the Craftex CX series bandsaws, or at least the CX104.