Mophie Magsafe Car mount

I was inspired by this model https://www.printables.com/model/84487-magsafe-car-mount/comments

I already used a steel ball magnet mount in my truck, so I decieded to make my own from scratch to utilize my existing ball mount. The steel ball mount can be seen in the last photo, there are many versions of this out here

5 minutes in F360, and 4 iterations later voila!

Dimensions of the holder are 56.55mm, with a depth of 5mm (actual end size depends on tuning of your printer

Using a steel disc (from a Wyze v2 cam) and 3M tape I stuck the disk to the underside if the Magsafe holder. This then magnetically connects to my exisitng stell ball mount, as in the penultimate photo

I choose white ASA, to cope with high temps and UV rays - however this white ASA always looks lumpy - but does the job