I remixed this model as I found the screw holes for for attaching the sensor to the part were too far forward. I didn't delete the existing mounting points from the part just added new mounting points so you get the best of both worlds. This works very well with my setup.
From the creator:
I am so tired of Creality Filament Run Out Sensors being so difficult to load that I designed a housing with confined path that uses the Creality V2 internal sensor component.
I printed on a resin printer for accuracy and smoothness.
I printed on the corner and angled in 2 directions, minimal supports.
Part screws into place in 2 minutes.
Let me know if you make this, love it, and please post your photo!
The author remixed this model.