Remix of this (https://www.thingiverse.com/thing:2957181) Diffuser for Convoy S series (high resolution version), so it can fit on my Convoy S21A.
I recommend reading Summary of the original project.
I don't think it's needed, but I used some type of raft for better adhesion.
I also recommend .12 layer height because of problems caused by internal overhangs on .20 layer height.
Printer Brand:
Creality
Printer:
Ender 3
Rafts:
No
Supports:
No
Resolution:
.10-.20
Infill:
0%
Filament: Plast-Spaw PLA White
Notes:
I set thickness to 2 lines (for good light transmittance) but as the author said in the original part comments section, you can experiment with that.
Category: ToolsThe user re-uploaded this model. The user is not the original author of the model. Imported from Thingiverse.