Mount bracket for Mackie ProDX8 mixer

Bracket to mount the Mackie ProDX8 mixer onto a surface
1
6
0
70
updated July 12, 2023

Description

PDF

This bracket fits the profile of the Mackie ProDX8 mixer and has screw holes to allow it to be mounted to a surface from the bottom.  It contains two screw holes and pockets for nuts sized to accomodate #8 hardware.  I used #8x32 7/8" flat head machine screw and corresponding nut.  The left bracket is provided - mirror it in your slicer for the right side.  Spacing between the holes on the bracket is 100 mm.

The nut pockets are on the inside of the bracket giving a clean look, but this does make mounting a little trickier. I will probably change that if I find a need to print it again.  I would also go for straight sides rather than tapered in a reprint, but since it works I don't want to waste the plastic.  The FreeCAD file is included for anybody who would like to make changes to the model.

It is intended to print oriented with the outside face down.  If your slicer does not have an automatic orientation feature, the angle of that draft is 8.64 degrees.

 

Model origin

The author marked this model as their own original creation.

License