Printed it with PETG (forgot support on bottom part, it's important..)
Printed with T3M Filament PETG transparent + Bambu PETG HF grey.
It houses LIVH 75C 7.6V LAVA 450mah batteries fine. Underneath the drone is place for 3 USB C chargers / checkers.
Ductaped a little magnet to the inside with a reset pin to pair my gear in the field :-)
Awesome! I have since learned thet putting rounded corners on the outside is a very bad idea... It was one of my first models XD
Sweet design! Probably will need to make the battery slots slightly bigger as its a tight fit for non betafpv batteries. Everything else is spot on.
@RobertVargas_993014 awesome,thanks! You can find a version with bigger battery slots on my Thingiverse page, havent updated it here yet!
@valentyn you're welcome!
