Rule #1 of 3D design... has someone else solved the problem?
Thanks for this, saved me some design-time :)
U6-IW ubiquiti in-wall stand
U6 in-wall used without the need of wall mounting.
22
379
3
2105
updated January 26, 2024
Makes
Comments
@ShawnThomas_1400343 You're welcome!
Love your design! Could you add a version for a 40mm fan please? My access point thermal throttles and I use a 40mm fan to keep it nice and cool. Thanks!
@PrinterPower_312604 How it should be done? Where to place fan?
@Tommi My current fan placement is around 5-15mm above the last bolt at the top. This is the place where the hotspot is.
Works good, would be nice if it was slightly taller. The ubiquity patch cords don't work with the design. To tight at the bottom.
View one more comment
@Tommi patch cords have about 2 1/4 inches from the access point until they can bend. I'm guessing 1/2 to inch more. Haven't measure it out exactly.
@hoocli_206690 You can try new version. There is one inch more for cords.
Fits and stably holds the U6-Enterprise-IW as well. The slot at the top for the removal tool is a nice touch. Thanks!
Love the design, simple and it works. Did a first print with PLA basic to see how it holds up vs Access Point warmth. Cheers and keep it up!
@RafFonteyn_1234286 How'd the PLA hold up?
Works just fine in terms of support, even after 1,5 years :-)
