Pandora - Hueforge

This is Pandora, created using the amazing Hueforge.

Comes in two sizes and thin/thick to choose, the large one will take quite some time to print. On the photo you see the small version.

As usual with Hueforge, this will require 4 colours to change on specific layer height and will consume minimal filament.

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

The thick model was created more recently with different colour combination and will take significantly longer to print.

Instructions (thick model)

Filaments Used:

• PLA Overture Black
• PLA PolyTerra Charcoal Black
• PLA Overture Cement Gray
• PLA+ Sunlu Gray
• PLA Overture Light Gray
• PLA+ Esun Bone White
• PLA+ Sunlu White

Swap Instructions:

• Start with Black
• At layer #5 (0.48mm) swap to Charcoal Black
• At layer #8 (0.72mm) swap to Cement Gray
• At layer #12 (1.04mm) swap to Gray
• At layer #16 (1.36mm) swap to Light Gray
• At layer #23 (1.92mm) swap to Bone White
• At layer #32 (2.64mm) swap to White for the rest.
   

Instructions (thin model)

Filaments Used:

• PLA+ Sunlu Black
• PLA Overture Chocolate
• PLA Overture Light Brown
• PLA+ Sunlu White

Swap Instructions:

• Black until layer #4 at 0.4mm
• Dark Brown until layer #10 at 0.88mm
• Light Brown until layer #18 at 1.52mm
• White for the rest.

Enjoy my work? Support me by joining my club. Tier 1 offers exclusive models, while Tier 2 allows you to sell my 3D printed artwork.