ACER KG272UP monitor supports

Replaces the stock stand that the monitor comes with, which takes way too much space. Sturdy and precise fit.
54h 3m
2× print file
0.15 mm
0.40 mm
497.00 g
0
14
0
155
updated July 8, 2023

Description

PDF

Hello,

Here is a print that went pretty well for me and is very useful. Replaces the stock stand that the monitor comes with, which takes way too much space.

Here are a few points to note with this solution :
- Fixed monitor inclination at 10°.
- Fixed monitor height of 5 cm.
- Surely blocks the speakers in a way or another (these are just above the stands).
- Back buttons are not blocked by the supports.
- It is a very big print, in terms of material (~500g of PLA for both = half a spool) and time (24-28 hours for each), and surely in electricity as well, print this if you are very sure about your monitor model and will to commit to printing left and right parts.
- This print could be avoided with books and cheap trickery, or just space.
- A lighter model can be made, I just wanted to make sure it was working (fit and stability) on the first try.
- The fit is tight (like no play at all, took 1mm of tolerance over measures, which were made with eye and ruler), but there is no grinding when fitting them and no post-printing work required.
- It was printed with no support, laying on the exterior side, on a Prusa Mini with PLA Prusament, with 20% fill density, on 0.15mm QUALITY preset from PrusaSlicer. I cannot say how other settings can affect the final fit or rigidity.
- Print at your own cost, risk and will ;)
- Very specific use case, but still might help someone, who knows ?

Cheers !

Tags



Model origin

The author marked this model as their own original creation.

License