DJI RC Necklace Support

After attempting some hand-Take-off-Landing with my drone, I found difficult to handle the RC with one hand and be confortable at the same time (May differs depending stick config).

This accessory is screwed directly on M4 and M2 threads on the RC, there is no modification of the RC itself.

It is light, flexible and easy to use with any necklace and made to be mounted/removed in a few seconds without any tool. Access to USB ports and mSD card is not obstructed.
Knobs provided are just there as exemples but any M2 & M4 will do the job.
You can as well lay the RC on the support as a stand.

Have fun & Fly safe!

Printed with Prusament PETG Urban Grey & Prusa Orange, defaults in PrusaSlicer 2.6