About this model:
Simple stand for the ROG Ally inspired by the one I did for the Steam Deck I tried to make this one a bit more “angular” to fit the general design of the ROG Ally.
2 Variants: One with a flat bottom and one that can accommodate 4x 12x3mm rubber feet like those.
Layer Height: 0.2mm
Infill: 15%
Support: None.
Material: Any, no report on deformation due to thermals yet.
If you enjoy or find this model useful this model please leave a Like or post a Make, also be sure to check my other models.
You can also consider supporting me by joining my club.
You can also get a commercial license if you'd like to sell prints of this model by joining this tier.
The author marked this model as their own original creation.