Keep your coasters organized with a holder that stays in place.
5
32
1
138
updated June 25, 2023

Description

PDF

Keep your coasters organized with a holder that stays in place. Designed for coasters ~100mmx100mm. There are variants uploaded from 2 to 5 coasters, but it's easily modified so if something doesn't work right for you send me a message and I'll upload a new one.

The cutouts on the bottom are sized for large Command picture hanging strips. Leave the “tail” piece attached and cut in half lengthwise.

Print Settings

Resolution: 0.1mm. There is bridging required for the bottom cutouts, and going much higher then this will make it not work as well.

Infill: 15% Gyroid

Supports: No

Tags



Model origin

The author marked this model as their own original creation.

License