I modified the original design to be smaller and remove the back to fit sitting on my sink's top properly.
I also added a “left” and “right” hole design to fit your needs on the power cable.
- print the bottom
- Print one of the two tops to fit your needs (left or right hole)
- Optional: Splice the two charger wires into one.
- join with 4 small wood screws from the bottom
- apply a little silicone around the chargers to keep water from flowing in.
I also recommend you print 2 of these to make it easier to clean by catching the toothbrush spooge: https://www.thingiverse.com/thing:5979375
Notes:
- These are high-poly designs to make smooth corners, but you can easily modify the scad for a low poly design
- I printed with .12mm height to make it smoothest, but .2 ought to work just fine
- I've printed this both in pla and petg. I like the look of pla more, but both work.
Tags
The author remixed this model.