Update 10/04/2021
After using my RC car for rougher terrain than a Touring chassis should do (paved slabs and a pothole ridden road) for a few months now, Ive found the wheel design weak when it comes to bumps at very excessive speed, can cause the part where the spokes becomes the outer dish to crack. Also crashing when drifting cracks it at the hub. I havent printed mine 100% infill which may help with this. Im yet to vapour finish to see the effects of this. See the 23/10/2020 for some more analysis points.
However, for road use with a decent surface this performs well, with the addition of looking the dogs nuts.
I will at somepoint attempt to fix this but I dont have the original file as its a remix and its so hard to edit a .stl in fusion.
====================================================================
Update - 23/10/2020
I am now happy with this model, tyre fits nicely and its the right size for a 1/10 Rc car.
Printed originally in Carbon fibre pla, then model was updated and printed in abs. ABS does not seem to be the right material of choice for this application as when crashed, the wheel snapped at the hub nut, perhaps a penny washer would solved this. At high speeds, the wheel is not cushioned enough and the outer rim cracks. Perhaps vapour finishing will improve this and remove the layer weakness issue. Carbon fibre pla seemed to hold up better during testing but was not extensively test due to the tyres de beading due to original design not suiting them.
==============================================
Remix of SILVERADORED's BBS wheel for a 12mm hub and 4mm stud, also slightly resized to accuarate 52.3mm diam.
Original size is 51.2 diam and 10mm hub with tight 3mm stud tolerance
To be printed and tested.
Category: R/C VehiclesThe author remixed this model. Imported from Thingiverse.