A little wall mountable holder for a 25mm NFC tag embossed with a logo to encourage scanning. I just used a marker to color the embossed logo, but I'm sure this could be printed with the graphic flat and with two colors to make that more permanent if desired.
The screw holes are intended to fit a standard drywall screw.
Printer Brand:
Anycubic
Printer:
i3 Mega X
Rafts:
Doesn't Matter
Supports:
Yes
Resolution:
0.2
Infill:
20%
Filament:
Hatchbox PLA White/Black
Notes:
Use supports on the cap.
Post-Printing:
Stick your NFC tag in the cap, and insert the cap into the mount.
Note that if you have too much elephant's foot on your print the cap may require a bit of cutting/sanding to fit.
Category: Electronics
The author marked this model as their own original creation. Imported from Thingiverse.