Sovol SV06 LED Light Strip Mount

This is a mounting system I made in order to install a 6mm wide by 12 mm tall LED light strip into the slots around the Sovol SV06 frame. This could be edited to be wider or taller, however, the vertical upright beams of the SV06 are 6.25mm wide, meaning the widest LED light strip I could fit was 6mm.

Print one each of the 5 Stud model, and the 6 Stud model, with the studs pointing up.

• PETG or PLA
• 0.2 - 0.3mm layer height
• 40mm/s
• 35% infill
• Supports recommended 

Press the studs into the SV06 horizontal gantry, orientation does not matter. It may help to slightly heat the studs with a heat gun or hair dryer to get them to fit into the holes easier. They are tight, so if you remove them, a stud may break off in the gantry - also easily removed with heat.

I had to print mine in two parts, since the full length is too long to fit onto the SV06 print bed, but I have included the full length model if desired.

Here is the link to the LED light strip I bought: eBay 6mm Cool White LED Light, 1 meter
I also used this 24v step down converter to take the 24v ouput from the stock SV06 power supply and reduce it down to a usable 12v, 10a: Amazon 24v to 12v step down converter