iPhone13/14 phone holder for Toyota GR-Yaris, left/right hand drive

Disclaimer: Using phone holders/stands in a car is prohibited by traffic regulations in some countries. Use on your own risk.

Phone width

This holder component fits iPhone 13/14 case width about 75.5 ~ 76mm. Slightly scale the holder in the width direction still works.

The width test component is a small section of the holder component for a quick test fitting. Scale the width test in the width direction and print it until it fits your phone case. Apply the same scale ratio to the holder.

Materials

• ABS or ASA filament (PLA is not recommended for its low temperature in a car scenario)
• Bolt M5 x 45 (1)
• Bolt M3 x 15 (2)
• Hex nut M5 (1)
• Square nut M3 (2. Hex nuts are applicable but could spin more easily)
• Washer M3 x 8 x 1.0 (2)
• Polyurethane sticky pad 6cm x 8cm
• 3M VHB tape

Slicer

• For right-hand-drive users, just mirror the joint in the slicer. The other 2 components are symmetrical.
• Wall: 1.6mm or thicker
• Infill: 20% or more
• Use supports.