original page: https://www.thingiverse.com/thing:5224200
I made this remix because the original keycaps didn't fit onto my Kailh Box switches.
I can recommend using PLA, since that worked for me very well. I've also tried PETG, it works, but you will not get as clean results as this.
This part can be printed without any supports. If that doesn't work for you however, you can try these support settings:
Support Overhang Angle: 20 degrees
Support Pattern: Lines
Support Density: 20 %
Support Z Distance: 0.265
Support Horizontal Expansion: 0.2
Support Interface Thickness: 0.4
(source: https://youtu.be/QaE7YPvh4E8 )
The user re-uploaded this model. The user is not the original author of the model.