Vertical adapters for "An even simpler simple spool holder - for the P1P with ARC enclosure"

I needed to change my desk config a bit and move the spool holder which was sticking out the side to be over the top of the unit.

This is unapologetically not caring about and AMS installed, its for a spool fed p1p's.
 

Prerequisite models: even simpler spool holder, arc spool roller, original bambu spool holder

Upper bracket - this utilises 2x 10mm m3 bolts, 2x 30mm m3 bolts, 2x m3 nuts

Lower bracket - this needs 2x 30mm m3 bolts

 

Installation is fairly straight forward.

Upper bracket - using the 2x10mm bolts, bolt the new adapter to the simple spool holder arm. Use the 30mm m3 bolts and nuts  thread them through the spool roller and through the adapter - clamping down on the spool arm

Lower bracket - Use 30mm bolts to mount the bracket to your p1p, slot in the spool arm - this doesnt actually need the bolts in the middle to hold the arm into the bracket - gravity and friction do the rest.

You can reverse the lower bracket model in your slicer and have it fit backwards if you wanted to.