Gears Vector Customized Parts

Customized optional parts for the Gears Vector by Gears13th.  The BCAR utilizes the original geometry from Epicxxxx and is mated to the seating system from Gears13th.  The open muzzle notch is on the top.  If your top notch is not top dead centre, then sand/file the seating tabs a little to get it to rotate further.  As per the Gears Vector original instruction, you will need a thinner (less deep) M3 heat set insert just like the original muzzle.  I used a typical heat set insert in our hobby and dremel cut it down on my personal build.  IMPORTANT: If you have already made you Gears Vector, you may need to adjust the height of your wheels to best align with the BCAR.  When it was an open muzzle, the tolerance didn't matter as much but now it does.  The more aligned the wheel heights are, the less FPS loss you will experience.  If you are building a new Gears Vector, use OldFusionDesigns wheel height spacer guides and start from the thickest.  It's easier to push wheels down than it is to pull them off.

The front shroud cover insert is glued in place.  Print on highest resolution for the cleanest logo.

The handstop is a clean version without the Kryptek cam pattern on the face.  It is designed to replicate the lines of the original lower receiver.

Get the full set of files for the original Gears Vector here…

https://www.etsy.com/ca/listing/1463905211/gears-vector-digital-file-stl?ga_order=most_relevant&ga_search_type=all&ga_view_type=gallery&ga_search_query=gears+vector&ref=sr_gallery-1-1&bes=1&organic_search_click=1