SodaStream CO2 Adapter Wrench

Designed up this because I got a SodaStream Fizzi OneTouch and the spot for the bottle is a bit recessed. I use an…
0
16
0
378
updated June 1, 2023

Description

PDF

Designed up this because I got a SodaStream Fizzi OneTouch and the spot for the bottle is a bit recessed.

I use an adapter hose to hook a 10Lb CO2 cylinder up to the SodaStream, but there was no room to get my fingers in there and tighten it in place, so.. OpenSCAD to the rescue!!

This tool is shaped like the top of a SodaStream gas cylinder. Just loosely screw your adapter into the SodaStream , then use the wrench to tighten it. Because this wrench is the same diameter as a stock bottle, it is less likely that you will over-tighten the adapter.

I have used it, and it does work for me. Hopefully it will help someone else!

This is the SodaStream adapter I use it with: https://www.aliexpress.com/item/32905523965.html

Print Settings

Printer Brand:

Creality

Printer: 

Ender 3

Rafts:

No

Supports: 

No

Resolution:

200

Infill: 

38

Filament: Generic PLA White


 

Notes:

 

20% infill for most of it.
You may want to use 100% for the top 15mm or so, but if you're using a good PLA, PLA+ or something, it's probably ok with 20%.

I recommend printing with a brim as there's not all that much contact area at the base and it is fairly tall. That said, you know your printer, so use your judgment.

How I Designed This

Designed in OpenSCAD

Notes:

There are a few variables you can tweak, most notably, you can turn on a test mode that will print a short 10mm tall version of the wrench so you can be sure it fits your adapter!

 

 

 

 

Category: Kitchen & Dining

Tags



Model origin

The author marked this model as their own original creation. Imported from Thingiverse.

License