Printed in white PETG, worked great!

Works well and I love the design!

16

Andreagattonero

@Andreagattone_581314

Brilliant design, many thanks for sharing 👍

Perfect

Good case but the posts that fit inside the mounting holes of the Pi are a bit thin.

13

mychaos

@mychaos

Printed it on my MK4 out of ASA but as I had the 0.25 nozzle on and needed that afterwards again I did not change it...

Seems tolerances are to good so the bottom and top part are perfectly fitting but the connection is not pressed and thus it's loose... so I'll reprint it

One comment, a lot of people seem to use pla, as the Zero can each up to 80° in enclosures I find the pla glass temperature of 60° to low for that. This should be PETG or something else which can withstand hotter temperature.