Nintendo Switch OLED handheld mode grip

Designed to be printed without supports.

My printing settings:

1. Material: Overture Rock PLA (I don't recommend this specific brand personally, for the first layer likes to warp, but YMMV. The looks are dope NGL.)
2. Temp: 220/70
3. Layer height: 0.2mm
4. Line width: 0.4mm
5. Infil: 20%
6. Brim: Yes but not necessary, if you have a better adhering material.

Fit: Fits my switch OLED just fine, not loose, not too snug. If you want a snuggier feel, try scaling the model down to 99.7% (i.e. reducing the width by about 1/32")