Orion Mount v3

Remix of several Things, all of which are referenced

I like the concept of the Piezo but have had some challenges with the one prior to the Orion. I've remixed several hot end mounts with it, along with dual RJ45 connectors for ease of removal. https://www.thingiverse.com/thing:2970968

These were then remixed using the mount from NedalLive's brilliant designs that had also been tweaked by TypQxQ

I don't like brass inserts so removed all bar one from Moriquendi's excellent Orion mount kit

When you print the duct make sure to create some supports but NOT any on the inside or you will never get them out. I used S3D and created custom supports

I did manage to do a little work in Fusion 360 but had to bail and go back to Tinkercad as my skill with F360 sucks :o(

Update

Photos are the v2, in use and working, but the height was wrong for the top section of the mount

Messed up on the height of the back where the RJ45 mount goes and 2 of the mounting holes where too short. This has been fixed in v3, just finished printing one. Will test and photo the results