SAMLA HANGA (modified version)

This is a modification of SAMLA HANGA by jan Grewe. It is a holder for a dry box solution using an IKEA 22L SAMLA box.

The SAMLA HANGA by Jan Grewe (https://www.thingiverse.com/jangrewe/) has a very nice design. But some weak points were the motivation to do the following changes:

• Some enforcements have been added to avoid breaking at mounting frame and at the beginning of the triangle.
• I formerly used a 40mm tube but this has some more friction. When changing to a smaller aluminium tube, the filament was hanging quite low. Now the angle of the triangle has been increased. If you change the diameter of the tube, the height of the filament will not change so much anymore.

Print instructions

Rafts: Yes
Supports: No
Resolution: 0.2mm
Infill: 100%

Notes: I added some small support which can be removed easily. But I printed it successfully even without.