This is the Y gantry bottom parts for the VzBoT Vz330 used to replace X gantry to lower cost, lighter weight 1515 size instead of 2020 size.
The geometry and shape is based on the Vz330 V1.2's Y gantry except for minor differences and is fully compatible.
note: After the Vz330 V1.2 is released, the left and the right of the Y gantry are not common parts. If you are using less than V1.2, please re-printing and combining Y-gantry-top-left and Y-gantry-top-right released by official VzBoT.
Part | STL | PCs |
Left Bottom | This Y_gantry_1515_bottom_left-15.2.stl | 1 |
Right Bottom | This Y_gantry_1515_bottom_right-15.2.stl | 1 |
Left Top | The official Vz330 V1.2's Y_gantry_top_left.stl | 1 |
Right Top | The official Vz330 V1.2's Y_gantry_top_right.stl | 1 |
X end stop | The official Vz330 V1.2's XendStop.stl | 1 |
note: The standard inner width is 15.2 however please try to use 15.1 or 15.0 instead of 15.2 if your fitting is too loose. For my VzBoT I used 15.2 but use 15.0 now to use CF-ABS that is low shrinkage instead of standard ABS.
Type | Weight(440mm) | Moment of inertia of area |
A6063S−T5 square tube 15x15xt1.5 | 97g | 0.249×10^4 mm^4 |
Misumi HFS3-1515 | 150g | 0.280×10^4 mm^4 |
MakerBeamXL | 147g |
Side dimple marks show the direction of the part. Illustrated below are the left part, the tooth side is the front and the smooth side is the back.
The author remixed this model.