Anycubic Kobra Low Profile 2x LED Strip mount

I wanted super low profile attachment to put lighting on my Kobra Go. I had been using a clamped on gooseneck lamp but it was very obnoxious and obtrusive. 

I printed this in PLA+ and have black light strips currently attached to it and it is holding up fine. They do not get hot enough at all for it to warp, and I have it held up on velcro strips on both sides in case it decides to work it's way free. 

The cords run through the upright arm, I wedged them in the groove of the vslot where the roller is. 

Depending on your printer settings, you may need to scale 101%