[SV06 / SV06 Plus] Filament Guide for use with Dryer

Printed everything for the plus however I dont see how the pulley lines up to the filament guide in the middle. Haven't assembled yet, just dry fitting everything at the moment.

I may attempt to make a retainer bracket. I say attempt because I don't know 3D modeling, so it may take me a while, but I am imagining a U shaped part that goes around the outside of the parts that hold the bearing rollers that would be held on by the M3 screw holding the rollers. Of course it would require replacing the M3s with longer screws. I will upload a remix if I can get around to figuring it out, but if someone is faster than me, I think it would be a useful part. Excuse the crude mockup, it was quick.

Printed on and for a regular SV06 (I don't have a filament run-out sensor). I needed this because I didn't have enough vertical real estate for the stock filament holder.

Used PLA. The bearings in the wheels seem to have a lot of resistance and don't seem to spin that freely.

Printed the left piece (2 wheel thing) with tree supports.

Used 25 mm screws.

I personally used a heat gun, but I'm sure you could get away with using a hair dryer instead.

(The filament spool sits on "TUSH - The Ultimate Spool Holder") (edited)

Am I going to need to print with supports for the "filament holder left"?

Definitely need 2 25mm M3 the dual pulley piece.

Getting ready to print this. Can you post or tell us where you got the filament runout sensor stl?