Spool Reroll Drill Attachment

This is a 3 parts print to allow you to use a drill to respool filaments. There are better engineered, fancier but also longer and more plastic consuming options. This isn't one. This is a quick print to get it done.

For the rod, I suggest to use at least 20% and/or 4 walls since it will be undergoing stress a lot.

Instructions:

• Screw the two parts of the tool on both sides of the empty filament spool
• Pass the rod from the male end to the female end of the tool, If possible, make the rod go all the way out through the female end but this is not mandatory.
• Attach a bit of filament to the empty spool
• Attach the excess end of the rod to your drill
• Activate the drill by slowly increasing the speed (also slowly deccelerate when done, don't do abrupt start or end)
• Profit