10 way water manifold

For a project I was working on I required 10 small water jets which displace the same pressure while stemming from one water inlet tube, so I designed this manifold. It works well but if some of the outlet tubing is significantly shorter or longer tube there will be a slight difference in the water pressure. It is designed to be mounted to 20x20 extrusion but it could be mounted to anything. There is a 4mm through hole located on the tab. The inlet is designed for 9.0mm ID sized tubing and the outlets are designed for roughly 2mm ID. 

When printing I would recommend printing with at least 4 or 5 perimeters to minimise leakage.