The Filter - Magnetic, for Voron Trident

This is a remix of The Filter, which personally I like better than the Nevermore. 

The Filter was exclusively designed for the Voron 2.4 but I have a Voron Trident so I designed this mount that allows your to install The Filter under the Trident bed. Mounting it under the bed allows for heating up the chamber faster.

There are two parts that differ from the original The Filter model; 1) the housing was tweaked to remove the pogo connector hole on the front, and holes for inserting magnets into the side and back of the body was added, and 2) the mount is new and custom designed with magnet holes to attach to the housing.

You will need twenty-four (24) 3x6mm neodymium magnets. Make sure they are strong magnets. Twelve (12) magnets go into the body of the housing, and twelve (12) magnets go into the inside of the mount. The magnets fit in with some pressure so you may need a pair of pliers to push them in. Make sure they sit flush (or as flush as possible) with the surfaces. It might be possible to get away with a total of twelve magnets (six on the housing and six on the mount) but I personally haven't tested the holding strength of the magnets like that – let me know if you try it.

Wiring is up to you and there are lots of different ways to do it. I suggest you take inspiration from The Filter and Nevermore. Personally I used WAGO 221 connectors, but a JST fan splitter cable or an inline splicing connector might be a better way to do it.

Mounting orientation is also up to you. You can point it towards the back of the chamber, to the side, front, and you can mount it on either side of the bed. 

You'll need two (2) M3x8 screws and two (2) M3 roll-in t-nuts (hammerhead t-nuts will probably work too) to attach the mount to the extrusions under the bed.

If you have any issues or suggestions feel free to reach out to me on the voron discord @adrianocr