I think this version could use more work. It needs supports which were pretty difficult to remove. It is hard to stack for more tokens or dice. Otherwise I like that it imitates gametrayz.
I would love to see a lid that snaps on and some other mentioned adaptions.
You need support to print this. It is a nice design. I just printed one so I don't know if it is stackable.
Excellent first version, I would suggest improvement to be able to print it with no support and may be different sizes, I was looking for something to shuffle my tokens, this one is too small.
Tried to print it but it failed.. because i thought the bottom of the tray would be on the bed.. but first 4 mm's are just the stackable edge so you would need alot of support to print this.. can you lower the bottom?
@H_137548 Based on your attempt, if I trimmed the stackable edge so that it is flush with the rounded bottom, do you think that would work out?
@iamrobertv make it, and ill try :D
