Threaded Bearing Holders remixed for Ikea 465+ 10.6L food container drybox

This is remix of https://www.thingiverse.com/thing:4246377 and https://www.thingiverse.com/thing:4570340/remixes.

With the remix bearing holder by 3opaH you don't need to buy any nuts as the bearing holder is threaded. Because they were to wide to accommodate two full size 1kg prusa filament spools in the Ikea 365+ 10.6l containers, I remixed the bearing holder to accept a bearing on both sides, so you don't need two bearing holders in the middle of the rod. I also slimmed down the other bearing holders. You need to print 12 of the slim bearing holders (file Pos2) and 2 of the center bearings (file Pos6).

Print the center holder with supports, because the inner ring is not flush with the outer ring. Otherwise the print will fail.

Print Settings

Printer Brand:

Prusa

Printer:

Prusa Clone

Rafts:

No

Supports:

No

Resolution:

200

Infill:

20

Filament: Prusament PLA Galaxy Black

Notes:

Print the center holder with supports, because the inner ring is not flush with the outer ring. Otherwise the print will fail.