This is for mounting the SFS to a panel with drilled 6 mm holes for screws and 14 mm hole for the fitting diameter. Remove the back lid and use the printed part instead. You will need new M3 screws as the original ones are too short.
CHECK THE HOLE DIMENSIONS! I had to print this twice as the CAD model I found was probably of a different version of the SFS. This is the one I have:
https://biqu.equipment/products/btt-sfs-v1-0-smart-filament-sensor-detection-stuck-blocking-filament-module
BOM:
2x M6 bolt + nut (+ washers)
6x M3 screw 10 mm (8-12 mm long should work)
The author marked this model as their own original creation.