If you need a size that I dont have, just let me know and I'll get to it as soon as I can!!
Cant adjustable from 0 to 70°
You do not have to take this apart to adjust the cant. Loosen the arc screw and pivot screw (pivot screw is behind the ELS shown in silver, access it through the left ELS mount hole), set it where you want and tighten it back up.
Retention is adjusted with an M6 screw that is buried in the MRD. I will add a thumb screw to mine for quick and easy adjustment.
If you need right hand loading just mirror the angle plate and mag pouch in your slicer.
Print pouch upside down on the angle with supports “Everywhere” and overhang angle set at 60.
I print with 0.6 nozzle set at 0.24 layer height, wall count at 10, 5 tops and bottoms, infill 75% triangle for all parts.
BOM - Single Mag Pouch
(1 each) printed parts - Mag pouch, MRD, Angle Plate
(1) ELS Mount
(5) M5 x 12 Flanged Button Head Cap Screws
(5) M5 x 5.8 x 7.1 Heat set insert with lead-in
(2) M5 x 20 Flanged Button Head Cap Screws
(2) M5 Nuts. Mine came in an assortment set, im sure you can get them on amazon as well. Truss nuts or Chicago nuts would look better but with where the nuts are the dont bother me to be regular hex nuts.
(1) M6 x 16 Thumbscrew (or regular screw) DIN 653 Steel Flat Knurled Thumb Screws, Blackened Finish | JW Winco Standard Parts
About the heat set inserts. I only use the heat sets with the lead-in and for these you need to insert from the back of the part. You cannot access the back of the holes in the mag pouch with a soldering iron so I made the holes a “little more than snug” interference fit and put a step at the end of the hole. So you will need to use some needle nose pliers and put the lead-in end of the heat set in to the hole from INSIDE the mag pouch, then put a washer and M5 screw on the outside and start cranking it down until the end of the heat set is clear of everything on the inside. It doesnt take long and surprisingly they hold REALLY well. The mag pouch in the picture was a prototype, thats why there is a 3rd hole
UPDATE 12012024 -
Added 14x42 357 Mag pouch
UPDATE 12162024 -
Added 1911 Mag pouch
The author marked this model as their own original creation.