About a year and a half ago I was on a quest to remove as much clutter as I could from the top of my desk. I've gotten better at it over time, but this is one of the first things I made.
This fits some older generation Astro Mixamp Pro (and TR models). The fit is a little bit loose (I didn't get the angle exactly right), but putting a piece of rubber (I wadded up a rubber band) gives a good tight fit against the desk and no moving parts.
Printed with 0.2mm layers in Prusament PLA, this was printed with minimal supports for the fastener ‘wings’.
The author marked this model as their own original creation.