60mm Lens Cap

This is a remix of the Thingi found here

I basically just resized it to fit 60mm and then I put some branding on it, to match the lens I was printing it for (so I don't confuse it with other cap/lens combos). I've dubbed this the "Ultimate Red Dot" version, since I printed it in red PLA :D

There areTHREE parts needed for this cap, but I've included FOUR in this project, so that you can choose the branded (Leica) faceplate, or you can use (or mod) the blank faceplate if you prefer. Either can be used, but you don't need to print both.

To see actual prints of my design, check out the “Makes” tab (I print basically everything I design.)

Worth also saying that, IIRC, I set my printer setting to match the ones provided by the original thing (mentioned above), so if you give it a go, you can start there as well.