Print-In-Place Folding Laptop Stand (Easier print remix)

The original model has a very small contact patch on the hinges and requires stronger bed adhesion than I could consistently achieve. This is a few minor changes to support the print in place hinges during printing. The small contact area kept having the ones in my print popping off, even after tweaking the print settings. As a result, the print is more consistent, and the hinges are much smoother, at the cost of the hinges having to be broken free after the print but the original required some of that type of cleanup anyway. 

Also added a notch like a slide bolt to keep the pins from coming out of the through holes, slightly improving stability. 

Follow the original print settings with one change.

First layer wall width: 0.24-0.25

Make sure ‘Detect thin walls’ or your slicer's equivalent is off. 

Also uses the adjustments from this earlier remix: https://www.printables.com/model/162688-print-in-place-folding-laptop-sta