Nerf PCAR "Plush" rifled suppressor

A new approach to effective, light weight, and accurate nerf short dart suppression. Replace all of the heavy and volume-wasting internal baffles with nearly weightless synthetic maze material. Yes, its stuffed with polyester poly-fil stuffing. 

Operating Principle: High pressure gas escapes from behind the dart into holes at the base of the rifled tube. The only way forward is towards the muzzle through dense but breathable polyester fiber. The pressure of the air is reduced as it moves through the stuffing, lowering blast noise as the air exits through holes in the muzzle cap. 

The rifled suppressor uses Sillybutts' SLAB spigot remix of Thanhtacles' trivictus rifling profile. Holes are cut between the rifling at the base of the tube. The cap should fit tight but some electrical tape is recommended for heavy use. The suppressor is attached with Sillybutts' o-ring nut system.

Required ‘hardware’: polyester poly-fill stuffing (a large handfull), 016 o-ring. 

Designed to fit a 16mm barrel.

Disclaimer: Only for use with low powered airguns like Nerf foam dart launchers. Will not fit on a firearm. Do not print if you own any firearms (constructive posession). Airguns are not firearms federally, but your local laws may apply.