Scooter Umbrella Holder

This is an umbrella holder with a removable tube for when not in use. This is for a 9 degree back.

Base is 80mm wide and 140mm tall. Base .3mf has a small base layer added to ensure bed adhesion.

Printed with six perimeters on the base and four perimeters on the holder. No supports.

Drilled holes for the mounting on the back rest. Mounted with screws and T nuts. This way they don't stick out on the rider's side.

Ensure your extrusion calibration is dialed in for your filament to ensure these pieces fit correctly. There's enough tolerance for the holder to slide on to the base but not have a loose fit.