Biqu h2 v2s revo cpap fan duct

This was designed with what I had on hand in mind; if I make any changes I will likely update this.

This was actually one of my first ever models so remixes are welcome and heavily suggested as I'm sure someone else can come up with something else much better than what I made.

The duct is also designed to use m3 heat set inserts.

Thanks for at least checking out my model, and extra thanks if you actually use it, but special thanks if you make a remix that works better than mine which I'm sure someone can as this is pretty bad.

I might try to add onto it at some point a bracket so that it also attaches to the screw holes near the fan the only thing it that it'd be hard to have it adjust on that as well and some versions of the biqu h2 don't have them.

The adjuster attaches onto the body of the h2 through the 2 screw holes next to the motor and the spacer is to get the distance of it and the duct to the correct position.

The mount I am currently using is this https://www.printables.com/model/323734 slightly modified to fit on the normal ender 3 plate 

I am also using this linear rail kit for my X axis https://www.amazon.com/UniTak3D-Upgrade-Conversion-Carriage-Included/dp/B09M73XRBH/ref=sr_1_6?crid=1N9XF6U7ZJXJ1&keywords=ender%2B3%2Blinear%2Brail%2Bkit&qid=1682318793&sprefix=ender%2B3%2Blin%2Caps%2C89&sr=8-6&th=1 

With these linear rails which aren't the best but work well enough https://www.amazon.com/Iverntech-Linear-Carriage-Printer-Machine/dp/B0B4P9YLSB/ref=sr_1_15?crid=30LR707ILJQ59&keywords=linear%2Brail&qid=1682318853&sprefix=linear%2Brial%2Caps%2C92&sr=8-15&th=1 

The cable chain I thing I'm using is this https://www.thingiverse.com/thing:2654426/files but I do plan on getting an actually good cable chain like this https://www.amazon.com/LMioEtool-Plastic-Carrier-Length-Connectors/dp/B07QYM8XQ7/ref=sr_1_6?crid=1HZ1BT4QXWJOV&keywords=lmioetool&qid=1682319159&sprefix=lMio%2Caps%2C86&sr=8-6&th=1  that will mount to the thing I printed

I am also using the kevinakasam belted z

The fan solution I am using currently is this https://www.printables.com/model/418203-dual-5015-to-cpap-manifold 

Finally uploaded pictures they suck but they get the job done I guess

I used Pla in the pictures but I am about to print it all in petg which you should also probably do