A1200 Back Trap Door MicroHDMI, Network and internal microSD

I modified the back trap door with slots for 1xMicroHDMI, RJ45 network.and a slot to keep the microsd case in place.

The Micro HDMI connector socket is designed to hold the Micro HDMI Type D Female FPC Connector Socket with a flat cable. Search ebay for "Micro HDMI Type D Female FPC Connector". https://www.ebay.com/sch/i.html?_from=R40&_trksid=p2047675.m570.l1313&_nkw=Micro+HDMI+Type+D+Female+FPC+Connector&_sacat=0

Recommended hdmi cable lenght is 20 cm.

Here is a package with hdmi female, male and cable: https://www.ebay.com/itm/Type-A-Male-FPC-to-CYFPV-Straight-HDMI-Female-Flat-Cable-for-HDTV-Multicopter/382598636360?ssPageName=STRK%3AMEBIDX%3AIT&var=651361237516&_trksid=p2057872.m2749.l2649

And here is a microhdmi connector https://www.ebay.com/itm/Micro-HDMI-Type-D-Female-FPC-Connector-Socket-for-HDTV-Aerial-Photography-CYFPV/132669876039?ssPageName=STRK%3AMEBIDX%3AIT&_trksid=p2057872.m2749.l2649

I have this (25cm) as my microsd extender: https://www.ebay.com/itm/New-25cm-Micro-SD-Memory-Card-Slot-to-TF-Card-Extender-Cable-Extension-Linker/303304935817?ssPageName=STRK%3AMEBIDX%3AIT&_trksid=p2057872.m2749.l2648

I use this microhdmi to hdmi cable: https://www.ebay.com/itm/150cm-Micro-HDMI-Male-to-Standard-Male-Cable-Lead-Full-1080p-Tesco-HUDL-1-2-EU/162120162262?ssPageName=STRK%3AMEBIDX%3AIT&_trksid=p2057872.m2749.l2648

Get some flat ribbon cable for the network module, and remove the top on one end or else it will be touching the floppy drive. See pictures for description. https://www.ebay.com/itm/10pcs-10pin-2-54mm-IDC-Flat-Ribbon-Cable-Wire-for-Atmel-AVR-ISP-JTAG-DownNWUSHH/303636924114?hash=item46b22bc6d2:g:DEwAAOSwfLxbEfQf

• Screws:
• One M2x10mm for the ENC28J60 Ethernet Module LAN
• Two M2x6mm to hold the microhdmi firmly in place

I use it on my Amiga 1200 with a Vampire 1200 accelerator.

Print Settings

Printer Brand:

Creality

Printer:

CR10S PRO

Supports:

Yes

Resolution:

0.2mm

Infill:

40%

Notes:

No need for support for the clip. The clip should be printed with 100% infill