Prusa Extruder Rotation Visualizer Turbine
All design credit goes to ZekeAsakura https://www.thingiverse.com/thing:2900552 I remixed it as follows: Reduced the…
83
959
16
4269
updated July 23, 2019
Makes
Comments
Pretty cool, couple a printed times and the top always looked like crap.
Pretty cool design and it printed well. The only issue I had was the recess for the magnet was a little too deep. As a result the visualizer is flat against the extruder casing. Not sure if the casing is thicker or the motor is more recessed. Easy fix with either two magnets or adding a small cylinder to it in the slicer. Thanks for the design!
Looks good but I found that with the sunken magnet hole, the part would rub against the motor so I printed a little 8x2 cylinder and glued it in before I added the magnet and that added enough separation for me to be happy with.
