Cable Spine (Updated 03-07-2023)

The perfect way to manage your dangling cables!

In the past I have tried various options when it comes to cable management such as zip-ties, cable-sleeves and the go-to cable-chain with the small latches but none of them felt right to me.

Changelog

Version-2 Release:

• Tolerances are now a default of 0.1mm across the board.
• The width of the arms are now 2mm by default seeing how the slightly thinner ones were slightly too brittle.
• A guiding shaft has been added (roughly 3mm wide) to allow for a wire of filament to be inserted as a guide and extra rigidity for the whole assembly.
• A mounting-plate version has been included to allow assembly directly onto a 2020 extrusion with a variation of m3 and m4.
• Version 2 is backwards compatible with version 1.

Version-1 Release:

• 0.00mmcl (no clearance socket)
• 0.25mmcl (0.25mm clearance socket)
• Wide (Wider version)
• Thin (1.2mm wide clamps)
• Thick (2.0mm wide clamps)

This part was designed and created within Plasticity, can't upload the file because Printables doesn't support it :/

If you have any questions or remarks, leave a comment or shoot an email to kyniverse+printware@gmail.com