This is a very large (552.83 x 417.99 x 25.4mm) sculpture of the BloodHoundAD logo. It was originally made as wall decor for the SpecterOps offices. Now you can make your own!
The BloodHound.stl file is the complete model. You scale it down to fit your print bed or whatever size you like. I recommend scaling it and then unlocking the scale to adjust the Z-axis on its own. Keep the model 12.7mm (0.5") or taller if you want it to stand easily on its own.
If you want to go BIG, there are individual pieces. I have cut the model to create individual chunks that are roughly the same size and fit back together easily. There are enough connection points that gluing should be a cinch (everything is basically self-aligning).
I have included a gcode file for PLA on the Prusa i3 MK3S. The hound is scaled to near full print volume (a little less to allow for a skirt). It is 228.6 x 172.84 x 12.7mm (roughly 9 x 7 x 0.5").
Print however you like with any nozzle and layer height. No part of the hound requires supports if you print in the default orientation. It may not even need supports if printed in a vertical position; however, that would leave very little surface area on the print bed. Vertical prints might get knocked over and fail.
Scale down the full hound for an "no assembly required" print or print one of each of the parts. Scale all parts equally and assemble using CA glue.
The author marked this model as their own original creation.