Compact Xbox Controller Wireless Adaptor Shell

Xbox Wireless Controller USB Adaptor Shell. I created this because the original is very long and doesn't allow me to push my computer back against the wall. The black case is the original, the white is the new.

The adaptor I'm using is https://www.amazon.com/gp/product/B08CY14VGD

1. The PCB must be trimmed as shown in the pictures to shorten it. It is very obvious where you can trim. Use a sharp blade to score a deep line across the board then bend it to snap it at the line.
2. Desolder the stabilizing tabs on the edges of the USB connector.
3. Bend the USB plug 90 degrees.
4. Optional: Solder small stiff pieces of metal back onto the USB connector and through the PCB to help stabilize it again. I used some extra through-hole pins I had laying around.
5. Once all the pieces are ready to go together, use a couple tiny dabs of super glue around edge of top case.