Pinecil v2 case w/ power supply

Remix of Pinecil v2 case w/ space for 65w GaN power brick.
20
117
0
1968
updated April 18, 2023

Description

PDF

This is a remix of “Pinecil rugged case” with a few tweaks:

Print here was done in 2-tone PETG, printing the top and bottom as single pieces using the Bambu x1c w/ AMS. Seal was printed with 95A TPU. It should also be printable in parts, just make sure to split the .step into pieces. I haven't added STLs, but they should be pretty easy to extract from the .step, if you want (but… I don't recommend this because the tolerances will be worse).

Please refer to “Pinecil rugged case” for assembly instructions, though I actually used round bar stock w/ CA glue for all the hinges/latches in the print pictured (I think if I do it again I would rethink this a bit: I like the unthreaded contact surface for the rotating/latching parts, but CA doesn't work AT ALL to connect steel w/ PETG :)).

Reel / Stand models: https://www.thingiverse.com/thing:4571953/files

Tags



Model origin

The author remixed this model.

License