SV06 Plus Bed Cable Strain Relief
This part essentially takes the supplied bed cable strain relief and extends the support out and angles it up a little.
99
981
9
3449
updated April 24, 2023
Makes
Comments
does anyone know how to fit this part on to the new sv06 plus? the stock strain relief part is screwed on from under the non removable magnetic surface so I can't get to the screws with out pulling of the non removable magnetic surface
@Jack_393069 I'm intrigued by that fan cover. What fan mod are you using?
Looks like newer versions of the SV06 Plus are no longer compatible with this. The underside of the plate is extended further under the base plate and appears to be somehow screwed into from above, so it's not possible to remove the bottom plate for replacement. (edited)
View 2 more comments
@NashChhatwal_1337801 link gives a 404 error.
How do you remove the existing holder? there's like no videos on how to. I have the newest version of the sv06 plus with the thick rubber cable
View 2 more comments
I don't get it either. I cannot even think about how they assembled original part in the first place.
@TheGameKille_1052939 the new models make it impossible to get the screws out because their screwed in from under the magnetic surface
No complaints about the print, came out really well, however I could not fit the cable into the holder and looking at the images on here I think they have changed the cable on newer models (I received mine a couple of days ago). Going to have to amend the file to suit the new (thicker!) cable
View 2 more comments
@enog82_943258 The channel is modelled at 8.2 mm currently. How much larger do you think it needs to be to suit the new cable? Or are the ribs the issue?
@LukeDehtiar_515401 Just checked it again and the cable does fit at the furthest end from the bed (with it not fitting near the bed I didn't really look at the other end so much!), so probably removing the ribs would solve it
This model relieved any concerns about the heat bed cable rubbing or getting caught against the frame of my SV06 Plus, many thanks!
Printed with SUNLU PLA at 15% infill, with supports.
Tip: Make sure to cinch down the zip tie closest to the bed to ensure the part doesn't rub against the printer!
