Braun Multiquick Hand Blender Part Optimized for Prusa i3 MK3S

I remixed the original gear and optimized it for my Prusa i3 MK3S printer.

I tweaked the physical size of the hole in the bottom of the gear. This fits nice and snug on my blender. The original part came off too easily.

I have also modified the "hat" on the top. It previously had an overhang. I have just modified it to be filled. It increases strength and still fits the mixer perfectly.

Please leave a comment if you successfully make this!

Print Settings

Printer Brand:

Prusa

Printer: 

I3 MK3S

Rafts:

Doesn't Matter

Supports: 

No

Resolution:

0.1mm

Infill: 

100%

Filament:

Generic PET White

Notes:

I found printing it in PET 0.1mm made a nice strong gear.
I did however find that at about the 75% point there is a possibility the model will break away from the bed. Its right on the limits and will depend on your heat bed stickiness. You could always use a raft to be safe but I fixed this by slowing down the printer to about the 75% mark and it seemed to hold on a bit better.